Interior view of the 3D model of the workbee's port underside window. The windows translucency is simulated.

Screw the Window Frames

I finally completed modeling the mounting hardware for the underside windows on the workbee. It actually entailed rebuilding the inside “window” edge of the components. This was due to not leaving the inside face of the window opening vertical. Instead I had it at the 41.5º angle which is the average outside slope of the underside angled hull in the area of the window location.

Continue reading

Underside Windows

This past week I spent working out the precise design and shape of the underside windows of the workbee. While at first blush, this would seem to be a fairly straight-forward task, working it out as if it were a “real” vehicle that would need to operate in the vacuum of space made it pretty challenging.

Continue reading
Workbee traveling overhead the U.S.S. Enterprise while she is in dry dock.

Greebles Down-Below

Over the past week, I have been working on modeling the underside “greebles” of the workbee. Thanks to some reference images I got awhile back, I was able to make some more headway. I pretty much have all the detailing on the underside completed but will need to make final positioning of the lower windows and the package monitor/control panel points (panels) which are on the lower sidewalls.

Continue reading